1080p HD  PEN CAMERA. Charging Your  Pen (First time only, charge for 3 hours.) Plug the USB cable into the pen and plug the other end into your computer. (see diagram). Your  pen’s light will blink while charging. Once the blinking light turns solid, your pen is fully charged. Disconnect the  Cam Pen once the charge is complete. A full charge should accommodate about 1.5 hours of recording time. Insert the Micro SD Memory Card Gently, yet firmly slide the micro SD card into your  pen slot. You should feel resistance when your micro SD card is fully inserted into the pen. Approximately 1/8″ of the micro SD card will be visible when it’s inserted correctly. Power up the  Cam Pen by pressing the on/Off Button on the top of the pen for 3 seconds. (To power off, press on/Off Button for 3 seconds.) Check the status light to ensure the  Cam Pen has powered up properly. It will display a solid green LED light to indicate that the  Cam Pen is on and ready to record or take a photo. (Solid green light indicates Ready Mode.) Start recording with the  Cam Pen by pressing the on/Off Button on the top of the pen for 2 seconds. Check the status light. The LED will blink several times to indicate that recording is about to begin. Once recording begins, the light goes out (or a dim, delayed blinking light may occur) so it does not attract attention during a covert recording session. To stop recording, administer one quick tap to the on/Off Button on the top of the pen. The green LED status light will illuminate to indicate the  Cam Pen is in Ready Mode and prepared to take a photo or resume recording. Take a still photo by administering one quick tap to the on/Off Button on the top of the pen. The green LED status light will blink once to indicate that it has captured the photograph.